Filter
Top Products
Technical Information
G600 & G800 Electronic Dishwashers
Water leaks from the Turbothermic Fan Grille
Hose between Fan and Dispenser is blocked
- Inspect Hose and replace as necessary (5.9)
The PTC Flap is not closing correctly
- Inspect Flap – replace the Turbothermic Fan as necessary (5.9)
Poor drying results
Incorrect Dispenser setting.
- Adjust setting as necessary
Rinse Aid Dispenser Flap not properly closed. The Rinse Aid
Container filled with water during program operation.
- Flush the Dispenser, refill with new Rinse Aid
- Replace Dispenser assembly – as necessary (5.8).
Rinse Aid not being dispensed released.
- Ensure Dispenser is operating.
Note
Rinse aid should only be added’ with the door fully open so it can
flow properly into the Reservoir. Ensure the Flap is closed and locked.
No drying or drying too slow
Fan run-on time too short. (if applicable)
- Extend the Fan run-on time (6.2.2).
Fan not functioning.
- Check circuit, perform service as necessary.
Air Outlet does not open.
- Check the Release Element and related circuit
Drying option – not enabled
- Enable the Drying Option (6.2.2)
107