Filter
Top Products
Technical Information
G600 & G800 Electronic Dishwashers
6.2.4 Buzzer (As Applicable)
Applies only to fully integrated (Vi) dishwashers (except Plus series).
Can be used to add an audible alarm at the end of the program.
6.2.5 Fault Code (Retrieval)
Stores the last fault registered, to assist in troubleshooting.
Note
Any stored fault code must be cleared prior to performing any
troubleshooting.
6.2.6 Increase Temperature
Enables a higher temperature setting during heating. Refer to the
model specific Timing Chart for details.
6.2.7 With OR Without Water Softener
Used to enable or disable the Water Softener System.
“With Water Softener” = Water Softener is ON
“Without Water Softener” = Water Softener is OFF
Note
If the Water Softener is not needed, the Electronic should be
programmed “Without Water Softener”
If the Electronic is programmed “With Water Softener” the hardness
value (gph / ppm) must be programmed. See the model specific
Operating Manual for further information.
6.2.8 2nd Interim Rinse
An additional rinse between the first rinse and the final rinses can be
added. Refer to the model specific Programming / Service Mode
Section for further details.
99