Filter
Top Products
Cleaning the ice cube tray
Before the ice cubes drop down into
the drawer, they are collected in a tray
in the ice cube maker.
This tray should be cleaned regularly to
remove any stale ice or water.
^
Connect the appliance to the power
supply.
^
Open the top left drawer slightly.
^
Press the ON/OFF button on the ice
cube maker and the indicator light
will come on.
^ Empty the ice cube drawer.
^ Press and hold the ON/OFF button on
the ice cube maker for approx. 10
seconds (after 1 second the ice cube
maker will switch off and the indicator
light will go out).
The indicator light will flash.
^ Within the next 60 seconds, push the
ice cube drawer in as far as it will go.
The ice cube tray then rotates into an
angled position, which makes it easier
to clean.
^
Wait until the rotation has stopped
before continuing.
^
Now take the ice cube drawer out of
the appliance.
^
Clean the ice cube drawer and the
ice cube tray with warm water and
some mild dish liquid.
^
Press the ON/OFF button on the ice
cube maker.
^
Now put the ice cube drawer back in
the appliance and close it.
The ice cube tray will now return to its
original position.
The ice cube maker will begin to
produce ice cubes again within 6
hours.
It is important to clean the ice cube
maker if you will not be using it for
an extended period of time.
If you used dish liquid to clean the
ice cube maker, discard the first
three loads of ice cubes! They are
not suitable for consumption.
Cleaning the ventilation slits
^
The ventilation slits should be
cleaned on a regular basis with a
brush or vacuum cleaner. A build-up
of dust will increase the amount of
energy the appliance consumes.
Cleaning and care
40