Filter
Top Products
Technical safety
~
Before setting up the appliance,
check it for any external damage. Do
not install and use a damaged
appliance.
A damaged appliance may endanger
your safety!
~
If the connection cable is damaged
it must be replaced by a Miele
approved service technician to protect
the user from danger.
~
This appliance contains the coolant
Isobutane (R600a), a natural gas that is
environmentally friendly but flammable.
It does not damage the ozone layer and
does not increase the greenhouse
effect. The use of this environmentally
friendly coolant has, however, led to a
slight increase in the noise level of the
appliance. In addition to the noise of
the compressor, you might be able to
hear the coolant flowing through the
system. This is unavoidable, but does
not have any adverse effect on the
performance of the appliance.
Ensure that no parts of the cooling
system are damaged during
transportation and setting up of the
appliance. Leaking coolant can
damage the eyes!
In the event of damage:
- avoid open fires and any ignition
sources,
- pull out the plug,
- air the room in which the appliance
is located for several minutes and
- contact the Service Department.
~
The more coolant there is in an
appliance, the larger the room it should
be installed in. If a leak occurs,
combustible gases may build up if the
appliance is in a too small room.
For every8gofcoolant in the
appliance, the room must be at least
1m
3
in size. The amount of coolant in
the appliance is stated on the data
plate inside the appliance.
~
Safe operation of the appliance is
only assured if it has been installed and
connected in accordance with these
installation and operating instructions.
~
Before plugging in the appliance,
make sure that the connection data
(voltage and frequency) indicated on
the data plate corresponds with the
electrical supply.
These data must match in order to
avoid damaging the appliance. If in
doubt, please contact a qualified
electrician.
~
Do not connect the appliance to the
power supply by an extension cord or
power bar, as they do not guarantee
the required safety (risk of overheating,
for example).
Warning and Safety Instructions
9