Miele KFN 14947 SDE ed/cs Refrigerator User Manual


 
. . . the frozen food is thawing
because the freezer section is too
warm.
^
Is the room temperature lower than
the ambient temperature for which
the appliance is designed?
If so, raise the temperature of the
room.
Operating in a room which is too cold
will cause the cooling system to switch
off for too long, causing the freezer
section to become too warm.
. . . food has frozen together.
Use a blunt instrument, e.g. a spoon
handle or plastic scraper, to prise it
apart carefully.
. . . the alarm sounds and the alarm
off sensor is flashing.
One of the sections is too warm,
because
^
the door has been opened too
frequently, or large amounts of fresh
food have been placed in the
appliance at once.
^
the ventilation gaps are blocked.
Once the problem has been resolved
and the correct temperature has been
reached, the alarm indicator will go out
and the alarm will stop.
. . . bars light up in the temperature
displays.
Check the temperature display about 6
hours after switching on the appliance.
Only temperatures within the range the
appliance can display will be shown.
..."_F" appears in the temperature
display.
There is a fault. Call the Service
Department.
. . . the Change active charcoal filter
indicator is red.
^
Replace the active charcoal filters.
You can order replacement filters via
your Miele dealer or the Miele Spare
Parts Department.
..."nA" appears in the temperature
display.
The temperature has risen too high at
some point during the last couple of
days because of a power cut.
^ Touch the alarm off sensor whilst "nA"
is lit up in the display.
The temperature display will show the
warmest temperature recorded in the
freezer section during the power cut.
Depending on the temperature
displayed, you should check the
condition of food in the freezer. If it has
defrosted or started to defrost, check
that it is still safe to use and if so use it
as soon as possible. Defrosted food
may only be re-frozen after it has been
cooked.
The warmest temperature will show in
the display for about 1 minute. The
display will then revert to showing the
current temperature in the freezer
section.
Problem solving guide
51