Filter
Top Products
Removing the door closing device
^
With its exterior facing downwards,
place the appliance door on a stable
surface.
^ Leave the hinges open and remove
the screw in the mounting a.
Caution! When uninstalled, the door
closing device will snap shut.
^ Loosen the ball joint b using an
open ended wrench.
^
Remove the door closing device c
together with the ball joint.
Do not remove the door closing
device from the ball joint!
This will damage the device.
^ Stand the appliance doors up
individually, and loosen the hinges on
the front (hinges remain open).
^ Pull out the plugs a from the top,
middle and bottom (if the plugs are
not in the doors, the are included
separately in the packaging).
^
Remove the screws from all the
hinges b.
^
Relocate each hinge diagonally in the
opposite corner.
Do not close the hinges.
Risk of injury!
^
To tighten the hinges, use a power
screwdriver – the screws b are
self-tapping.
^
Use the plugs a to close the holes
on the opposite side.
Adjusting the door hinges
41