Filter
Top Products
This screen displays the software version of both the PLC and the PanelView. The Controller
will stay on this screen for about 10 seconds or you can touch the picture of the blender to
quickly skip to the Recipe Screen (Next Screen in sequence). The software versions are also
available on the Panel View Configuration Screen.
Figure 27: Display Main (Recipe) Screen
101
If not, the blender can be reconfigured for Quick Set, Percent, or Parts by entering the Setup
menu and pressing the Recipe Format key. Then select the mode following the key prompt on
the screen.
To access the Setup Menu to change the Recipe Mode and other controller features, refer to
the following pages of this manual.
Controller Set-up
This section describes the proper setup of the Slide Gate blending system control parameters.
These parameters are operator changeable; however, these items should only require setup
during the initial installation. Only authorized personnel should change them. For security
reasons, the menu that is used to access these parameters is password protected.
Many of the variables and setup parameters have been preset at the factory and do not need to
be changed. However, this section of the manual will address all of the blender setup
parameters that were available at the time of printing. The purpose of this is to familiarize the
reader with all the setup parameters and their usage.
A complete listing of all default values is provided at the end of this manual.
Recipe Entry Mode
Mixer Status
Start/Stop
Blender
Immediately
Stop Blender
Accept New Recipe
Go To Recipe
Book
Go To Inventory
Screen
New Recipe
In
p
ut
Feeder Type
Indicator
BF1-615.3 Chapter 3: 2BInstallation 37 of