Filter
Top Products
Additional Setup Parameters
The settings listed below are set at the factory and typically do not require any change.
1. From the “Recipe” Page, touch the Manufacturer’s icon and enter “5413”, then press
the “Enter” key.
Note: If the controller is set to Continuous Mixing, then the blender will run
continuously while the blender is operating. If it is set to “Timed
Mixing” then the mixer will run for the “Mixing Time” setting when a
batch is dumped into the mixer.
2. Touch the “Mixer and Dump Setup” key to enter the amount of time the mixer will
mix or the batch is dumped.
3. Enter a “Mixing Time” by pressing the number next to “sec”, this is the amount of
time to run the mixer after a batch is dumped into the mixing chamber. Remember
that if the mix time is too long you may get material separation.
4. Press the number next to “sec” on the “Remix Time” to set “Re-mix” off time. This
allows the mixer to come on between batches if the blender cycle time is very slow,
i.e. if you want the mixer to come on every minute, set this to 60 seconds. If you
don’t want to use this function, set the time to “0”.
5. Press the number next to “sec” on the “Dump Time” to set your dump time (A value
between “1” and “999” will need to be entered.). This feature is the amount of time
required to empty the batch hopper. (Set the time so that all the material in the weigh
hopper has a chance to be evacuated.)
6. Press the number next to “sec” on the “Dump Delay” line for the optional dump
delay setting. This is the amount of time to start the mixer prior to dumping material
into the mixing chamber. Set to “0” to disable this feature.
7. Press the number next to “Dump Cycles” to enter the number of times that material
will be dumped from the weigh hopper. This allows the dump valve to open and shut
repeatedly when the weigh hopper is empty to shake lose any sticking material. If
this feature is set to “1” then the batch will dump normally.
8. Press the number next to “sec” on the “Mixer Dump Time” to enter the amount of
time that the mixer will run while dumping material out of the knife gate below the
mixer. This feature assists in cleaning out the mixer.
9. Press “Done” to return to the “Setup” screen.
10. Press “Alarm Setup” on the “Setup” screen to look at the “Alarm Flags & Feeder
Setup screen.”
11. This screen allows you to change the way alarms on each feeder function. Enter the
feeder you wish to configure by pressing the corresponding feeder number under
“Select Feeder”. You can select “Stop if “Out of Material” which means if there is
any kind of alarm on this feeder, the blender process will stop (i.e. The feeder supply
hopper is out of material.) You can also set it to “Continue if “Out of Material.”
This mode will alarm but let the blender continue to operate or you can set it to “No
Alarm on Out of Material” mode. “No Alarm” mode does not set off any alarms. In
addition, an “Out of Material Alarm Silence Delay” specifies the amount of time
before an alarm will be set off.
12. Press “Done” to return to the “Setup” screen.
BF1-615.3 Chapter 3: 2BInstallation 43 of 101