Filter
Top Products
1
1
PRODUCT CHECKING AND PARTS IDENTIFICATION
Unpack the inverter and check the capacity plate on the front cover and the rating plate on the inverter side face to ensure that
the product agrees with your order and the inverter is intact.
zInverter model
• Accessory
· P-clip (for M4 screw)
Use this to ground (earth) the CC-Link dedicated cable. (Refer to page 19)
· Fan cover fixing screws (M3
×
35mm)
These screws are necessary for compliance with the EU Directive (
Refer to page 41
)
Capacity Quantity
FR-E720-1.5KNC to 3.7KNC, FR-E740-1.5KNC to 3.7KNC, FR-E720S-0.75KNC to 2.2KNC 1
FR-E720-5.5KNC to 15KNC, FR-E740-5.5KNC to 15KNC 2
Inverter model
Serial number
Capacity plate *
FR-E720-2.2KNC
E720 2.2 KNCFR
--
Represents the
inverter capacity [kW]
E720
Three-phase 200V class
E740
Three-phase 400V class
No. Voltage class
Rating plate *
Inverter model
Input rating
Output rating
Serial number
FR-E720-2.2KNC
E720S
Single-phase 200V class
Cooling fan
( Refer to the Instruction Manual (Applied))
Combed shaped wiring cover
( Refer to the Instruction
Manual (Applied))
Main circuit terminal block
(Refer to page 6)
Front cover
( Refer to the Instruction
Manual (Applied))
Operation panel
(
Refer to the Instruction Manual (Applied))
∗ Location of the capacity plate and the rating plate differs
according to the inverter capacity.
Refer to the outline dimension drawing.
( Refer to the
Instruction Manual (Applied))
LED (operation status
indicator)
( Refer to the
Instruction Manual (Applied))
Terminating resistor switch
(SW1) (Refer to page 17)
CC-Link communication connector
(2-port type) (Refer to page 19)
Standard control circuit
terminal block
(Refer to page 6)
Switch for manufacturer
setting (SW2)
Do not change the initial
setting (OFF).