Filter
Top Products
5
8. Remove the rinse drain piping from the unload end of the tank. To do this, remove three
sections of black hose connecting the drain piping together (see the illustration below).
The easiest way to remove the drain piping is from the rear of the machine.
Remove the nipple in the 90° elbow then remove the elbow from the tank fitting.
8A. Remove the 3/4" pipe cap from the fitting on the load end of the machine and
install it on the tank fitting at the unload end of the machine where the drain piping
was removed. Install the drain hole seal removed in 7A in the drain hole.
9. Reverse the direction of the drain trunk piping by loosening the drain valve union and
rotating the piping 180°. Tighten the drain valve union (see illustration below).
MD-44 Direction Field Conversion
MD-44 Direction Field Conversion
8
= Hose
9
(continued on next page)