Filter
Top Products
30
PETER’S SPECIAL WINTER BREAD
(Sweet Setting – Not for Timer )
All ingredients at room temperature
(70°F-80°/21°C-27°C)
7 – 8 oz. water 1/4 cup corn meal
1-1/4 tsp. salt 2-3/4 cups bread flour
2 Tbsp. butter or margarine 2/3 cup whole wheat flour
1 egg, large 2-1/4 tsp. active dry yeast
1/4 cup molasses
Measure all ingredients into bread pan in the order listed above, beginning with the column on
the left, followed by the column on the right. Select Sweet setting. Select crust setting if other
than “Medium.” Press the “Start/Stop” button to begin the breadmaking process. The display will
begin counting down the minutes until the end of the cycle. When the baking is complete, the
display will read 0:00 and the unit will signal (when this occurs, you may choose to press the
“Start/Stop” button to cancel the “Keep-Warm” cycle if desired). Remove the bread and enjoy!
N
OTE
: Once the “Start/Stop” button is pressed, the selected function(s) cannot be altered.
To make any changes once the process has begun, the unit must be stopped, reset and restarted.
To stop, press “Start/Stop” and hold for 2 – 3 seconds until signal sounds and the screen reverts
to the setting display.
100% WHOLE WHEAT BREAD – FAT FREE
(Whole Wheat Setting – Timer OK)
All ingredients at room temperature (70°F-80°/21°C-27°C)
1.5-Pound 2-Pound
Water 8 to 9 oz. 11 to 12 oz.
Salt 1-1/2 tsp. 1-3/4 tsp.
Honey 1-1/2 Tbsp. 2 Tbsp.
Molasses 1-1/2 Tbsp. 2 Tbsp.
Whole What Flour 3 cups 4 cups
Vital Gluten 1 Tbsp. 1-1/2 Tbsp.
Active Dry Yeast 2 tsp. 2-1/2 tsp.
Measure all ingredients into bread pan in the order listed above. Select Whole Wheat
setting. Select crust setting if other than “Medium.” Press the “Start/Stop” button to begin
the breadmaking process. The display will begin counting down the minutes until the end
of the cycle. When the baking is complete, the display will read 0:00 and the unit will
signal (when this occurs, you may choose to press the “Start/Stop” button to cancel
the “Keep-Warm” cycle if desired). Remove the bread and enjoy!
N
OTE
: Once the “Start/Stop” button is pressed, the selected function(s) cannot be altered.
To make any changes once the process has begun, the unit must be stopped, reset and
restarted. To stop, press “Start/Stop” and hold for 2 – 3 seconds until signal sounds and
the screen reverts to the setting display.