Filter
Top Products
- Eng-17 -
English
The feature allows you to cook most of your favourite foods by select the category only. Select the category of
food and then just press Start Button.The oven determines the microwave power level and the cooking time
automatically.
For best results on Sensor Cook, follow these recommendations:
1. The room temperature surrounding the oven should be below 35 °C.
2. Be sure the glass tray, the outside of the cooking containers and the inside of the microwave are dry before
placing food in the oven. Residual beads of moisture turning into steam can mislead the sensor.
3. Food should always be covered loosely, but completely, with plastic warp. (Do not use any snap closing lids.)
4. DO NOT open the oven door until 2 beeps sound and cooking time appears on the display Window. Doing so
will cause inaccurate cooking since the steam from food is no longer contained within the oven cavity. Once
the cooking time begins to count down, the oven door may be opened to stir, turn, or rearrange foods.
5. All food should have a covered stand time of at least 3 to 5 minutes.
6. DO NOT use if oven cavity is warm (from previously cooked foods).
7. If the temperature of the cavity is too high, sensor reheat feature can not be used. Display window will appear
"
".Sensor cook feature can be used again until the " " disappears.
2. Press Sensor Cook
Button
3. Select the desired
Category
Select the desired category by
turning the Sensor Menu Dial until
the desired food category number
appears in the Display Window.
(If desired, press More/Less
Button.)
4. Press
After the heat and humidity
is detected by the SENSOR
the oven will beep twice, the
remaining time appears in the
Display Window and begins to
count down.
1.
Put the food into
the oven
To Cook Food Using Sensor Cook
More/Less Button:
Preferences for food doneness vary
with each individual. After having
using Sensor Cook a few times, you
may decide you would prefer your
food cooked to a different doneness.
By using the More/Less button, the
programs can be adjusted to cook food
for a larger or shorter time.
Press More/Less button before
pressing Start button.
1 tap = More (Adds Approx. 10% time)
2 taps = Less (Subtracts Approx. 10%
time)
3 taps = original setting
If you are satisfied with the result of the
Sensor program, you don't have to use
this button.
IP4230_39X90KT_Eng_25_120726.indd 17IP4230_39X90KT_Eng_25_120726.indd 17 2012-7-26 16:50:042012-7-26 16:50:04