Filter
Top Products
– 16 –
Before Requesting Service
THESE THINGS ARE NORMAL
The oven causes
interference with my TV.
Some radio and TV interference might occur when you cook with the
microwave oven. This interference is similar to the interference caused
by small appliances such as mixers, vacuums, hair dryers, etc. It does
not indicate a problem with your oven.
Steam accumulates
on the oven door and warm
air comes from the oven
vents.
During cooking, steam and warm air are given off from the food. Most
of the steam and warm air are removed from the oven by the air which
circulates in the oven cavity. However, some steam will condense on
cooler surfaces such as the oven door. This is normal.
I accidentally ran my
microwave oven without
any food in it.
Running the oven empty for a short time will not damage the oven.
However, we do not recommend this.
PROBLEM
POSSIBLE CAUSE
REMEDY
If it seems there is a problem with the oven, contact an authorized Service Centre.
Oven will not turn on.
The oven is not plugged in
securely.
Remove plug from outlet, wait
10 seconds and re-insert.
Circuit breaker or fuse is tripped or
blown.
Reset circuit breaker or replace
fuse.
There is a problem with the outlet. Plug another appliance into the
outlet to check if the outlet is
working.
Oven will not start cooking.
Start Pad was not pressed after
programming
Press Start Pad.
Another program has already been
entered into the oven.
Press Stop/Reset Pad to cancel
the previous program and
program again.
The program has not been entered
correctly.
Program again according to the
Operating Instructions.
Stop/Reset Pad has been pressed
accidentally.
Program oven again.
The door is not closed completely. Close the oven door securely.
When the oven is turning
on, there is noise coming
from Glass Tray.
The roller ring and oven bottom
are dirty.
Clean these parts according
to care of your oven (See next
page).
The word “Child”
appears in the Display
Window.
The Child Lock was activated by
pressing Start Pad 3 times.
Deactivate Lock by pressing
Stop/Reset Pad 3 times.
“H97”, “H98” or “H00”,
appears in the display
window.
The display indicates a problem
with microwave generation system.
Contact the specifi ed service
centre.