English
- Eng-22 -
Care of Your Oven
Technical Specifications
* IEC Test Procedure
Specifications subject to change without notice.
BEFORE CLEANING:
Remove plug from outlet. If impossible, leave
oven door open to prevent oven from accidentally
turning on.
AFTER CLEANING:
Be sure to replace the Roller Ring and Glass Tray
in the proper position and press Stop/Reset Pad to
clear the Display Window.
Inside of the oven:
Wipe with a damp cloth. Mild
detergent may be used if the oven
gets very dirty. The use of harsh
detergent or abrasives is not
recommended.
Glass Tray:
Remove and wash in warm soapy
water or in a dishwasher. If grease
accumulates, clean with a non-
abrasive nylon mesh scouring pad and
a non-abrasive cleanser.
Outside oven surfaces and
back vents.
To prevent overheating
caused by blocked vents,
clean periodically with damp
cloth. To prevent damage to
the operating parts inside
the oven, water should not
be allowed to seep into
ventilation openings.
Oven Door:
Wipe with a soft cloth when steam accumulates
inside or around the outside of the oven door. This
may occur when the microwave oven is operated
under high humidity conditions and in no way
indicates a malfunction of the unit or of microwave
leakage.
Roller Ring and oven cavity floor:
Wipe the bottom surface of the oven with mild
detergent water or window cleaner and dry.
Roller Ring may be washed in mild soapy water
or dishwasher. These areas should be kept
clean to avoid excessive noise and scratching of
painted surface .
Control Panel:
• If it becomes wet, clean
with a soft, dry cloth. Do
not use harsh detergents
or abrasives on the Control
Panel.
Power Supply: 220 V 50 Hz 220 V 50-60 Hz 230-240 V 50 Hz
Power Consumption*: 5.4 A 1,150 W 5.1 A 1,150 W
Cooking Power*: 1,100 W
Outside Dimensions (H × W × D): 304 mm (H) × 555 mm (W) × 493 mm (D)
Oven Cavity Dimensions (H × W ×x D): 222 mm (H) × 418 mm (W) × 470 mm (D)
Glass Tray Diameter: Ø 380 mm
Operating Frequency: 2,450 MHz
Uncrated Weight: Approx. 14.3 kg
IP1208_38E70KP_Eng_07_070629.indd 22IP1208_38E70KP_Eng_07_070629.indd 22 2007-6-29 11:30:112007-6-29 11:30:11