Filter
Top Products
Configuring the Hotwire DSLAM
4-2
8000-A2-GB26-00
May 1998
The following tables list the basic steps you need to configure the MCC card and
the DSL and MVL cards.
For the Management Domain,
perform task . . .
On the . . . See . . .
1. Clear NVRAM if the Who Am I
screen does not appear.
MCC Card
Clear NVRAM,
page 4-3.
2. Set the IP address and Subnet
Mask.
MCC Card
Setting the IP Address and Subnet
Mask,
page 4-3.
3. Configure time and date. MCC Card
Setting Time and Date,
page 4-4.
4. Create SNMP Community
Strings and Authentication
Failure Trap.
MCC Card
Creating SNMP Community
Strings and Enabling
Authentication Failure Traps
,
page 4-5.
5. Create default route. MCC Card
Creating the Default Route
,
page 4-5.
For each Access Node, perform
task . . .
On the . . . See . . .
1. Configure VLAN(s) on DSL or
MVL cards.
DSL or MVL
Card
Configuring VLAN(s) on a DSL or
MVL Card
, page 4-6.
2. Select the Active VLAN on each
DSL or MVL port.
DSL or MVL
Card
Selecting the Active VLAN on each
DSL or MVL Port
, page 4-6.
3. Configure a default next hop
router for each VLAN.
DSL or MVL
Card
Configuring the Next Hop Router
for each VLAN
, page 4-7.
4. Configure static users. DSL or MVL
Card
Configuring Static Users
,
page 4-7.