Filter
Top Products
Configuring the Hotwire DSLAM
4-7
8000-A2-GB26-00
May 1998
Configuring the Next Hop Router for each VLAN
"
Procedure
To configure the default next hop router for each VLAN:
1. Select
Configuration
→
Bridge
→
Port VLAN
(A-E-C).
2. Enter the port number at the DSL Port #: prompt.
3. Enter e to edit at the Action(Edit/Activate/Deactivate): prompt.
4. Enter the IP address of the default next hop router for this VLAN at the
Enter IP address of default next hop router
(nnn.nnn.nnn.nnn): prompt.
5. Press Ctrl-z and save the changes.
Configuring Static Users
"
Procedure
To configure static users to get their peer address from DHCP:
1. Select
Configuration
→
Bridge
→
Client VLAN
(A-E-D).
2. Enter the port number at the DSL Port #: prompt.
3. Enter 0 or press Return at the Input Number: prompt.
4. Enter the IP Address of this user at the Enter Client IP address
(nnn.nnn.nnn.nnn): prompt.
5. Enter the IP address of the default next hop router for this client at the
Enter IP address of default next hop router
(nnn.nnn.nnn.nnn): prompt.
6. Enter the VLAN for this user at the Input VLAN ID: prompt.
7. Enter yes at the yes/no: prompt to save your changes.
NOTE:
For information on configuring dynamic users, see Chapter 3,
Service
Domain
, in the
Hotwire DSLAM for 8310 MVL and 8510 DSL Cards
Network Configuration Guide.