Filter
Top Products
8310 MVL and 8510 DSL Card Configuration
5-12
8000-A2-GB26-00
May 1998
DSL Configuration Service Node Screens
Use the SN Configuration screen to configure endpoint Service Node information.
" Procedure
1. Follow this menu sequence:
Configuration
→
SN Configuration
(A-F).
2. The SN Configuration menu appears. Enter the desired value on the selected
screen and field as shown in Table 5-5 and press Return.
Table 5-5. Service Node Options
SN Configuration A-F
Displays endpoint information for the 5620 DSL or 6310 MVL Service Node.
Port # – Enter the DSL or MVL port number (1 to 4).
SN Type – Model number of SN connected to the DSL port. For Model 8510, the SN is
5620. For Model 8310, the SN is 6310. (This field is read-only.)
System Name – 16 alphanumeric characters. Enter the name assigned to the SN.
System Contact – 32 alphanumeric characters. Enter the name or number of the
person responsible for the SN.
System Location – 16 alphanumeric characters. Enter the location of the SN.
Model Num – Model number of card. (This field is read-only.)
Serial Num – Serial number of card. (This field is read-only.)
Firmware Rev – Version of firmware. (This field is read-only.)
Hardware Rev – Version of hardware.(This field is read-only.)
CAP Rev – (For Model 8510 only.) Version of CAP chipset. (This field is read-only.)
MVL Rev – (For Model 8310 only.) Version of MVL chipset. (This field is read-only.)
Reset SN? – Yes/No. Enter yes to reset the SN and begin a selftest.
NOTE: Entering yes in the Reset SN field will temporarily disrupt the data path on
the specified DSL port while the SN resets.
SN Selftest Results – Pass/Fail. This field displays the results of the SN selftest, when
completed.