Filter
Top Products
INSTALLATION
16
L20-378 rev. 0 (9/12)
ON
OFF
DRAIN VALVE CLOSED
Solid State
I/0 ON/OFF
Switch
Solid State Melt
Switch
To perform these adjustments the following tools will be needed:
Manometer
Digital Thermometer (Temperature Probe)
DC Microammeter
DC Voltmeter
1.8.1. FILLING THE APPLIANCE
Refer to the following procedure to fill the cook tank prior to operation.
1. Ensure that the drain valve is closed.
2. Fill the tank with oil/shortening until the oil/shortening
reaches the level line(s). Never let the oil/shortening level
go below the MIN LEVEL mark stamped on the tank.
1.8.2. LIGHTING INSTRUCTIONS
There is nothing to manually light on the electronic ignition system. Pilot ignition is performed and
controlled by the electronic ignition system. Refer to the following instructions to light the
appliance.
1. Open the gas supply valves to the appliance.
2. Turn the gas valve knob to the ON position.
3. Turn the controller on.
Solid State Thermostat:
Assure the Melt switch is in the correct position.
Turn the I/0 (ON/OFF) switch to the I (ON) position
Computer and Digital Control:
Press the
*
button to turn the controller on.
*The specified button may appear slightly different then shown. Refer to
the operator’s manual for your appliance’s specific control type to
determine the exact appearance of each button and display.
4. The main burners will light and be controlled by the thermostat.
Note: If your appliance has a self cleaning burner system, the burners may make a
popping sound immediately after the main burners light during startup. This noise during
startup is part of the normal operation of the self cleaning burner system and should NOT
continue during normal cooking & idle periods. (SCB Only)
WARNING
Oil/shortening must completely cover the heat tubes at all times while appliance is on.
CAUTION
This appliance is not designed for cooking with water. Fill with oil/shortening only.
WARNING
During operation there is an open flame inside this appliance. The unit may get hot enough to
set near by materials on fire. Keep the area around the appliance free from combustibles.