Filter
Top Products
Spin Fryer I12 Cooking Computer
Pitco P/N 60149505
L22-355 Rev 1 Page 8 of 28
2.2 To Change a Product Key–Cook, Shake, Hold, Hold Pre-Alarm, Spin Time, and Spin
Speed:
For each product key, Cook, Shake, Hold, and Hold Pre-alarm times are set in this section.
With display showing , continue with the following section for each product
key to change. Press the
key.
Display will show . Press the desired product key to
change.
2.2.1 Cook Time
Cook Time may be set for each product key. To deactivate any product key enter a zero value
for cook time.
Display shows [nCK mm:ss] [TIME] where “n” is the key number, “CK” means Cook, and
“mm:ss” is minutes and seconds.
Use the product keys for numeric entry to adjust the current setting. Press the key
to save cook time and continue setup for this product key.
2.2.2 Shake Time
Shake time is an alarm that sounds during Cook Time to prompt operators that the basket is
about to perform a spinning process. Default for this value is zero, meaning the Shake Time is
inactive. To use Shake Time, the time value must be a non-zero value, and, must be set to a
value less than cook time.
Display shows [nSH mm:ss] [TIME] where “n” is the key number, “SH” means Shake, and
“mm:ss” is time in minutes and seconds.
Use the product keys for numeric entry to adjust the current setting. Press the key
to save shake time and continue setup for this product key.
Spin time for shake is set to 10 seconds, unless Spin Time section 2.2.5 is less than 10
seconds then they are the same.
Spin Rate for shake is same as Spin Rate section 2.2.6.
Note: The value entered for shake time is the time from the end of the cook.
2.2.3 Hold Time
Cooked product may stand in holding bins for a period of time. This timer produces an alarm
to inform operators to discard old product and start a new cook. Default for this value is zero,
meaning the Hold Time is inactive.
Display shows [nHD mm:ss] [TIME], where “n” is the key number, “HD means HOLD, and
“mm:ss” is minutes and seconds.
Use the product keys for numeric entry to adjust the current setting. Press the key
to save hold time and continue setup for this product key.