Filter
Top Products
Chapter 4
4-10
CDROM The system will boot from the CD-ROM.
SCSI The system will boot from the SCSI.
NETWORK The system will boot from the Network drive.
BBS-0 The system will boot from the first BBS (BIOS Boot
Specification) compliant device.
BBS-1 The system will boot from the second BBS (BIOS
Boot Specification) compliant device.
BBS-2 The system will boot from the third BBS (BIOS
Boot Specification) compliant device.
BBS-3 The system will boot from the fourth BBS (BIOS
Boot Specification) compliant device.
Disabled Disable this sequence.
Try Other Boot Devices
Setting the option to Yes allows the system to try to boot from other devices
if the system fails to boot from the 1st/2nd/3rd boot device.
Full Screen LOGO Show
This item enables you to show the company logo on the bootup screen.
Settings are:
Disabled Shows the POST messages at boot.
Enabled Shows a still image (logo) on the full screen at boot.
S.M.A.R.T. for Hard Disks
This allows you to activate the S.M.A.R.T. (Self-Monitoring Analysis &
Reporting Technology) capability for the hard disks. S.M.A.R.T is a utility
that monitors your disk status to predict hard disk failure. This gives you an
opportunity to move data to a safe place before the hard disk becomes
offline. Settings: Enabled and Disabled.
BootUp Num-Lock
This item is to set the Num Lock status when the system is powered on.
Setting to On will turn on the Num Lock key when the system is powered on.
Note: Available settings for “1st/2nd/3rd Boot Device” vary depend-
ing on the bootable devices you have installed. For example, if you
did not install a floppy drive, the setting “Floppy” does not show up.