Filter
Top Products
Chapter 4
4-28
Supervisor/User Password
When you select this function, a message as below will appear on the screen:
Type the password, up to six characters in length, and press <Enter>. The
password typed now will replace any previously set password from CMOS
memory. You will be prompted to confirm the password. Retype the password
and press <Enter>. You may also press <Esc> to abort the selection and not
enter a password.
To clear a set password, just press <Enter> when you are prompted to enter the
password. A message will show up confirming the password will be disabled.
Once the password is disabled, the system will boot and you can enter Setup
without entering any password.
When a password has been set, you will be prompted to enter it every time you
try to enter Setup. This prevents an unauthorized person from changing any
part of your system configuration.
AMIBIOS SIMPLE SETUP UTILITY - VERSION 1.41
(C)1999 American Megatrends, Inc. All Rights Reserved
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP/PCI CONFIGURATION
INTEGRATED PERIPHERALS
HARDWARE MONITOR SETUP
LOAD OPTIMAL DEFAULTS
LOAD FAIL SAFE DEFAULTS
SUPERVISOR PASSWORD
USER PASSWORD
IDE HDD AUTO DETECTION
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
ESC : Quit
↑ ↓ ← →↑ ↓ ← →
↑ ↓ ← →↑ ↓ ← →
↑ ↓ ← → : Select Item
(Shift)F2 : Change Color
F5 : Old Values F7 : Load Fail Safe Defaults
F10 : Save & Exit
Change/Set/Disable Password
Enter new supervisor password: