Filter
Top Products
Chapter 2
2-16
Power Switch
Connect to a 2-pin push button switch.
Reset Switch
Reset switch is used to reboot the system rather than turning the power ON/
OFF. Avoid rebooting while the HDD is working. You can connect the
Reset switch from the system case to this pin.
Power LED (F_P1)
The Power LED is lit while the system power is on. There are three types of
LEDs you can connect from the system case to the pin:
2-pin single color power LED: Connected to pin 5 & 6. The power
LED is not able to change its color. You can only choose Blinking in
the BIOS utility for the power LED to indicate the suspend/sleep
mode.
2-pin/3-pin dual color power LED: 2-pin LED is connected to pin 5 &
6. 3-pin LED is connected to pin 4, 5 & 6. The dual color power LED
is able to change its color to indicate different system states.
Therefore, you can select either Blinking or Dual (color) for the
power LED to show the suspend/sleep mode.
LED Status Description
Steady Green The system is in the full-on mode.
Blinking The system enters the suspend/sleep mode.
LED Status Description
Steady Green The system is in the full-on mode.
Blinking The system enters the suspend/sleep mode.
z When you select Blinking in the BIOS utility: