Filter
Top Products
18
be increased when other burners are in use. Are the
oven burner ports blocked with spilt food?
Oven temperature getting hotter as
the cooker gets older
If turning the knob down has not worked or only
worked for a short time then you may need a new
thermostat. This should be fitted by a service person.
The oven light is not working
The bulb has probably blown. You can buy a
replacement bulb (which is not covered under the
guarantee) from a good electrical shop. Ask for an
Edison screw fitting 15w 230v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
Open the oven door and remove the Handyrack (if
fitted) and oven shelves.
Turn off the power supply.
Unscrew the bulb cover by turning anticlockwise.
Unscrew the old bulb. Screw in the new bulb, screw
back the bulb cover. Turn on the electricity supply
and check that the bulb now lights.
Power supply - You think there
may be a problem with it
Check the socket by trying out another piece of
electrical equipment in it.
Power failure
In the event of a failure in the electrical supply the
hotplate may be lit using a match.
If there is an installation problem
and I don’t get my original
installer to come back to fix it who
pays?
You do. Service organisations will charge for their call
outs if they are correcting work carried out by your
original installer. It’s in your interest to track down
your original installer.
What cleaning materials are
recommended for the cooker?
See the ‘Cleaning your cooker’ section for
recommended cleaning materials. We do not
recommend Mr. Muscle, as it contains chemicals that
may damage the surfaces of your cooker.
Installation
You must be aware of the
following safety requirements &
regulations
Prior to installation, ensure that the local distribution
conditions (nature of the gas and gas pressure) and the
adjustment of the appliance are compatible.
This appliance shall be installed in accordance with the
regulations in force and only in a well ventilated space.
Read the instructions before installing or using this
appliance.
In your own interest and that of safety, it is law that all gas
appliances be installed by competent persons. Registered
installers undertake to work to safe and satisfactory
standards. Failure to install the appliance correctly could
invalidate any warranty or liability claims and lead to
prosecution. The cooker must be installed in accordance
with
All relevant Standards / Codes of Practice, in
particular BS 5440 Part 2 2000,
Any Gas Safety regulations.
The relevant Building / IEE regulations.
Provision of Ventilation
This appliance is not connected to a combustion products
evacuation device. Particular attention shall be given to
the relevant requirements regarding ventilation.
Location of Cooker
The cooker may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
NOTE:
An appliance for use on LPG shall not be installed in
a room or internal space below ground level. e.g. in a
basement.
All models are supplied set for use on either
natural gas or for use on LP gas.
They cannot be converted from one
gas to the other.
This appliance is designed for domestic cooking
only. Use for any other purpose could invalidate any
warranty or liability claim.