Filter
Top Products
15
A electrode notch B ignition electrode
Now fit the two trim rings, making sure that they are
sitting down properly.
Griddle
Always clean the griddle after use. Allow to cool
completely before removing. Immerse the griddle
plate in hot soapy water. Use a soft cloth or, for
stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE CLEANERS
AS THESE WILL DAMAGE THE SURFACE.
Control Panel and Doors
The control panel and control knobs should only be
cleaned with a soft cloth wrung out in clean hot soapy
water - but take care that no surplus water seeps
into the appliance. Wipe with a clean dampened
cloth then polish with a dry cloth. The oven doors
should only be cleaned with a soft cloth wrung out in
clean hot soapy water.
Grill
The face of the grill burner will darken with use - this
is perfectly normal. Any fat or grease will burn off. Do
not try to clean it - the small holes could get blocked
and affect burner performance.
The grill pan and grid should be washed in hot soapy
water. After grilling meats or any foods that soil, leave
to soak for a few minutes in the sink immediately
after use. Stubborn particles may be removed from
the grid by using a nylon brush.
Oven
Cleaning is easier if carried out while the oven is still
warm. Before cleaning, cover the burner to prevent
the burner holes becoming blocked.
The inside of the oven and inner door panel can be
cleaned using an approved cleaner see the table at
the end of this section.
Take care not to disturb the oven thermostat
temperature sensor at the top of the oven opening.
The enamelled oven burner trim (supplied with some
models only) can be removed for cleaning.
The oven burner trim hooks onto the front of the oven
burner bracket.
When refitting make sure that the trim is in the middle
of the front of the oven burner bracket.
The Oven side linings
The oven has removable oven side lining panels
that have been coated with special enamel that
partly cleans itself. This does not stop all marks on
the lining, but helps to reduce the amount of manual
cleaning needed.
The Cook & Clean panels work better above
gas 190°C. If you do most of your cooking
below this temperature, occasionally remove
the panels and wipe with a lint free cloth and hot
soapy water. The panels should then be dried
and replaced and the oven heated at 220°C for
about one hour. This will ensure the Cook &
Clean panels are working effectively.
Don’t use steel wool (Brillo) or any other materials
that will scratch the surface. Don’t use oven cleaning
pads.
Before cleaning the oven, cover the burner at the
rear to stop the holes getting blocked as you clean.
If they are accidentally blocked, clean them out with
thin wire, such as fuse wire.
Removing the Oven Linings
The lining panels can be removed for cleaning and
for cleaning behind. Remove the shelves first.