Filter
Top Products
22
Fit the Handles
Remove the 4mm Allen screws from the doors with
the hexagon key tool. Use the screws to fit the door
handles.
The handles should be above the fixings.
Remove the 4mm Allen
screws from the top corners
of the fascia and fix the front
handrail in position.
Fitting the splash back (optional)
Remove the two fixing screws (3mm hexagonal socket
head) and nuts that pass through the top of the rear
flue grille. Hold the splash back in position. From the
rear refit the 2 fixing screws and nuts.
Fitting a stability bracket
A stability bracket or chain (not supplied by with the
cooker) should be fitted when the cooker is connected
to a flexible gas supply.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
1. Place the cooker in its intended position and level the
cooker.
2. Draw a pencil line 100mm from the front edge of the
levelling feet.
3. Mark the centre line for the bracket by measuring
550mm from the left hand side of the cooker.
4. Lower the front roller and move the cooker forward.
5. Measure back from the pencil line 550mm to locate
the front edge of the bracket. Fix the bracket to the
floor.
6. Measure the height from floor level to engagement
edge in back of cooker. Add 3mm to this dimension
and assemble the stability bracket to this height. (i.e.
from floor level to underside of the top member) and
ensure the bracket does not foul the oven burner
assembly.
Gas Connection
view from the rear
The Gas supply needs to terminate with a down facing
bayonet. The rear cover boxes limit the position of the
supply point.
Because the height of the cooker can be adjusted and
each connection is different it is difficult to give precise
dimensions. Ideally the house supply bayonet should
be in the shaded area shown in the diagram. Although
a 900mm hose can be used, a 1250mm hose will allow
slightly more flexibility in the positioning of the bayonet
and make moving the cooker easier. The hose should
be fitted so that both inlet and outlet connections are
vertical so that the hose hangs downwards.
The connector is located just below the hotplate level
at the rear of the cooker.
The inlet connection on the cooker is ISO 7-1
internal. If you require a ISO 228-1 connection, find
the ISP 228-1 connector in the top pack. Apply a
suitable thread sealing compound to the ISO 7-1 end.
Screw the connector into the cooker inlet until it is
finger tight. Using two suitable tools, one on the inlet
on the cooker to make sure it is held steady and one
on the connector, tighten the connector into the inlet
on the cooker.
Minimum torque 12Nm.
Maximum torque 20Nm.
Connect the hose to the connector.