Filter
Top Products
16
Moving your cooker
Switch off the electricity supply.
The cooker is heavy, two people may be
required to move it. The cooker is fitted with one
roller at the front and two at the back. There are
also two screw down levelling feet at the front.
The front roller, designed for moving the cooker can
be wound down. The levelling tool that controls this
roller is in the storage drawer compartment.
Remove the storage drawer (by pulling it right
out and lifting it up slightly) and you should see
the levelling tool.
Your installer may not have left the levelling tool in
place. If not, locate it as shown. If you cannot find
the levelling tool, contact your installer. See the
Installation section of these instructions where your
installer should have written their contact details.
Turn the levelling tool clockwise, two full (180°)
turns. It will be stiff. The front of the oven will
rise slightly as the roller drops down.
Open the grill door and right hand oven door so that
you can get a good grip on the bottom of the fascia
panel as you move the oven.
Do not move the oven by pulling the hand rail,
door handles or knobs.
Move the oven a bit at a time, checking behind it to
make sure the gas hose is not caught. Make sure
both electricity and gas cables have sufficient slack
to move the cooker forward as you go along.
If a stability chain is fitted, release it as you
ease the cooker out.
When you replace the cooker, wind it down off the
rollers by turning the levelling tool anti-clockwise.
This is important. It will stop the cooker moving
accidentally, while in use.
When you replace the cooker, wind it down off the
rollers by turning the levelling tool anti-clockwise.
This is important. It will stop the cooker moving
accidentally, while in use.