Filter
Top Products
18
ArtNo.800-0106 - Fitting the door
B
A
ArtNo.800-0111 - Marking
the plate position
ArtNo.800-0105 - Fitting the plastic hooks
Fig.5-8
Fig.5-9
Fig.5-10
ArtNo.800-0107 - Securing the door
Fig.5-11
The adjustable feet allow the dishwasher to be raised up to
870 mm. If the space between the oor and the underside
of the work surface is more than 870 mm, the unit should be
positioned on suitable wooded spacers that should be xed
to the oor (Fig.5-5).
Always use a spirit level to make sure that the appliance
is level left-to-right and front-to-back. If the appliance is
installed on carpet, make sure that there is clearance beneath
the appliance.
Adjust the feet to raise and level the dishwasher to the correct
height (Fig.5-6). Using the tool supplied, adjust the rear feet
via the studs ‘A’ at the front of the appliance. Adjust the front
feet ‘B’ using the spanner provided.
To prevent damage to the oor surface, install the appliance
on the plastic skids supplied.
Fitting the Decor Door
Fixing the door panel fittings
Place the template supplied on the back face of the door
panel. Align the top of the template, as identied by the
‘A’ arrow, with the top of the door and align the side of the
template with the left-hand edge of the door (Fig.5-7). Using
a pencil or bradawl, mark the positions of the holes closest
the door panel edge.
Repeat this step for the right-hand side of the door panel
using the other side of the template.
Align a mounting bracket with the two marks on the lower
left-hand part of the panel. Mark the remaining hole in the
top of the bracket (Fig.5-8) and then remove. Repeat for the
other side.
At the points marked, carefully drill 2mm holes to a
maximum depth of 10mm. Take care not to drill through to
the front face of the door panel.
Position the two brackets on the panel, with the tab facing
downwards. Using the screws supplied, x the brackets to the
panel.
Secure the two plastic hooks to the holes at the top of the
panel (Fig.5-9).
Mounting the door panel to the dishwasher
Insert the top plastic hooks into the slots on the dishwasher
front ‘A’. Carefully slide the panel up the channels until it
stops. Slide the panel downwards ‘B’, moving the bottom of
the panel door so that the bracket tabs locate into the slots in
the dishwasher front (Fig.5-10).
Align the top of the door panel with the adjacent cabinets.
Gently open the dishwasher door while supporting the door
panel. Secure the door panel using the screws supplied
(Fig.5-11). Cover the screw heads using the plastic caps
provided.
Note: If you have diculties tting the door (for example,
if doors are already tted to adjoining cabinets) then pull
the dishwasher out slightly to allow for easier access for the
door tabs. With the door tted, push the appliance back into
position.