Filter
Top Products
9
Switching the dishwasher OFF
Several minutes after the programme has ended:
1. Open the door.
2. Set the ON-OFF button to OFF.
3. Remove dishes, etc. when they have cooled down.
Note: For the best drying performance, we recommend that
you do not remove the contents for at least 30 minutes. This
allows residual heat in the dishwasher to remove any small
droplets of water that may occur.
Interrupting the programme
A cycle that is underway can be modied if it has only been
running for a short time. Otherwise, the detergent may have
already been used, and the appliance may have already
drained the wash water. If this is the case the detergent
dispenser must be relled; see ‘Loading the detergent’.
To cancel a programme that is underway, carefully open
the door and press the programme button and hold it in for
about 3 seconds.
CAUTION!
There is a risk of water coming out from inside the
appliance. DO NOT open the door fully until the
spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times
every thirty seconds.
If the appliance has already heated up or the hot water was
switched ON and then the appliance door opened, leave the
door ajar for several minutes and then close.
After 30 seconds the programme will start from the point it
was interrupted.
Cancelling or modifying a cycle
A cycle that is underway can be modied if it has only been
running for a short time. Otherwise, the detergent may have
already been used and the appliance may have already
drained the wash water. If this is the case, the detergent
dispenser must be relled (see ‘Loading the detergent’).
To modify a cycle that is already underway, follow the
instructions contained in the paragraph entitled ‘Reset drain
function’ and select the programme you wish (see ‘Switching
the dishwasher ON’).
Using 3-in 1 Detergent Tablets
General Advice
1. Before using these products you should rst check
that the water hardness in your supply is compatible
with their use, as per the detergent manufacturers
instructions (on the product packaging).
2. These products should be strictly used according to the
detergent manufacturers instructions.
3. If you encounter problems when using 3-in-1 products
for the rst time then please contact the detergent
manufacturers care line (the telephone number is given
on the product packaging).
Special Advice
When using combination products, the rinse-aid and salt
lights are no longer useful.
It may be helpful to select the lowest possible setting for
water hardness.