Roper D975 Oven User Manual


 
LIFT-UP COOKTOP
The cooktop can be raised so the area underneath can be
cleaned.
Raise the front of the cooktop until the support rods snap into
position to hold the cooktop.
To lower cooktop, push in on the front of the supports while
lowering top.
Porcelain enamel can chip. Handle porcelain enameled
cooktops carefully.
REMOVABLE OVEN RACKS
Be careful not lo scratch the oven finish when installing
or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pair of rack
guides.
2. Push the rack in until you reach the bump in the rack
guide, then lift the front of the rack a btt and push the rack
all the way in
To remove:
1. Pull the oven rack out, then up.
REMOVABLE OVEN DOOR
To remove:
1. Open the doorto the broil stop position (see illustration).
2. Grasp the doorat each side and lift up and off the hinges.
NOTE: When the door is removed and hinge arms are at
stop position, do not bump or try to move the hinge
arms. The hinges could snap back causing an injury to
the hands ordamage to the porcelain on the front of the
oven. Cover the hinges with toweling or empty towel
rolls while working in the oven area.
To replace:
1. Hold the doorover the hingeswith the slots at the bottom
edge of the door lined up with the hinges. The hinge
arms must still be in the stop position.
2. Slide the door down onto the hinges as far as it will go
and close the door.
STOP POSITION
19