Filter
Top Products
INSTALLATION
IMPORTANT: Save these instructions for the local electrical inspector’s use.
TOOL LIST
LOCATION
Hand or electric drill
Hand or saber saw
Pencil
Ruler or tape measure
Straight edge
l/8” drill bit
l
Put the range near a work surface for convenience.
l
The cooktop should be easy to reach and lighted with
natural light during the day.
ADDITIONAL MATERIALS
This range is designed to hang from the counter top. It does
not rest on the floor.
l
To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located
above the surface units should be avoided. If cabinet
storage space is to be provided, the risk can be reduced
by installing a range hood that projects horizontally a
minimum of 5 in. beyond the bottom of the cabinets.
If countertop is less that 1-1/2”thick, reinforcing braces must
be installed under the countertop, on each side. See figure
below.
RANGE SUPPORT
l
See Figures 1 and 2 for all rough-in and spacing dimen-
sions These dimensions must be met for safe use of
your range.
l
A wiring junction box must be installed in’ an adjoining
cabinet or under the floor. The junction box must be
located where it will allow considerable slack in the 4 ft.
long range conduit, so that the range can be pulled
forward for servicing if necessary. See next page for
more information.
BRACE SCREWED TO
UNDERSIDE OF
COUNTERTOP
Adloining vertical cabinet or wall above countertop
Ins& back wall 01 cabinet
1 -l/2’ Mmimum
546” Minimum flat
-_~-_-
must be smooth
Exact
:ig. 1
CUTOUT TOP VIEW
dimension must extend
to flat area.
flo”om
18” of cabinets on either
of cablnet above range
Fio. 2
2
EINS24-3