Filter
Top Products
PROBLEM
POSSIBLE CAUSE
SOLUTION
Burner flames
Air/gas mixture is incorrect.
Contact an authorized Roper
lift off ports, are
service technician to check air/gas
yellow, or are mixture.
noisy when
turned off
Burner makes
Burner is wet from washing.
Let dry.
popping noise
when on
Control knob(s) You are not pushing in before
Push control knob(s) in before turning
will not turn
turning.
to a setting.
Cooking results The range is not level.
Level range. (See Installation
are not what Instructions.)
you expected
The oven temperature seems
Adjust the oven temperature control.
too low or too high.
(See “Adjusting the oven temperature
control” on page 13.)
The oven was not preheated
Preheat oven if called for in recipe.
as the recipe calls for.
The recipe has never been
Use only tested recipes from a reliable
tested or is not from a reliable
source.
source.
The pans are not the type or
Refer to a reliable cookbook for recom-
size recommended in the
mended pan type and size.
recipe.
There is not proper air circu-
Allow 1% to 2 inches (4-5 cm) on all
lation around pan when
sides of the pans for air circulation.
baking.
There must be a minimum space of
1 inch (2.5 cm).
Flame size does not fit the
cooking utensil being used.
Adjust flame size to fit cooking utensil.
When broiling, you have not
Completely close broiler drawer.
completely closed the broiler
drawer.
24