Filter
Top Products
Before You Call For Service
If you are having an operating problem,
check the chart to see what the cause
might be before you call for assistance.
OPERATING PROBLEM
Nothing
operates.
Oven will not operate.
CHECK IF
m Range is properly connected to gas
and electrical supplies.
. Your home’s main fuse has blown or
circuit breaker has tripped
. Control knob is set in the correct
position.
. The flow of combustion and/or
ventilation air to the range is blocked.
. The electronic controls are set cor-
rectly. See pages 4-7.
. You have programmed a delay start
time.
WHATTOJIO
n
Contact an authorized Rope? service techni-
cian to reconnect range to gas and/or electri-
cal supply. (See Installation Instructions.)
I Replace
fuse
or reset circuit breaker. In case
of prolonged power failme, manually light
burners (see page 4).
I Set control knob correctly, if needed.
n
Remove blockage to airflow to and around
range.
. Reset controls, if necessary.
Burner fails to light.
. Range is connected to electrical
power.
. Your home’s main fuse has blown or
circuit breaker has tripped.
. Burner ports are clogged.
n
Contact an authorized RopeP service techni-
cian to reconnect range to electrical supply.
(See Installation Instructions.)
n
Replace fuse or reset circuit breaker. In case
of prolonged power failure, manually light
burners (see page 4).
n
Clean with a cotton swab, soft cloth, or
medium- to stiff-bristle tooth brush (see page:
9 and 12).
Burner flames are uneven.
. Burner ports are clogged. . Clean with a cotton swab, soft cloth, or
medium- to stiff-bristle tooth brush (see page!
9 and 12). If this fails, call an authorized
RopeP service technician for service.
Burner flames lift off ports,
n
Contact an authorized Rope? service techni-
are yellow, or are noisy
when turned off.
cian to check air/gas mixture.
LI;~F popping
noise
.Bumer is wet from washing. . Let dry.
Page 14