Filter
Top Products
CARE AND CLEANING
For best performance and safety, keep the oven ctean
inside and outside. Take spec a[ care to keep the inner
door panel and the oven front frame free of food or
grease build-up.
Never ese rough powder or pads, Wipe the
microwave oven inside and out, including the hoed
bottom cover, with a soft cloth and a warm(not hot)
mild detergent solution. Then rinse and wipe dry. Use a
chrome clearer and polish on chrome, meta_ and
aluminum surfaces. Wipe spatters immediately with a
wet paper towel, especially after cooking chicken or
bacon. Ciean your OVeRweekly or more often, if
needed.
TEMPERATURE PROSE
Remove the temperature probe from the socket after
each use. Ctean the probe with a mild detergent
solution. C_eanthe sensor with a soft, damp ctoth,
Use a pot holder because rife wire_ plug, and
sensor sections may be hot,
METAL RACK
Wash the metal rack with a mild soap and a soft or
nylon scrub brush.Dry completely.
Do not use abrasive scrubbers or cleaners to clean
rack.
CLEANING THE GREASE RLTERS
7,-_. grease fitters should be removed and c}eaned
ofen, at least once a month.
1. To remove grease filters_ slide each
fitter to the side. Pull filters downward
and push to the other side. The fitter will drop out.
'_
3. To reinstall the fitters slide it into the side sfet_ then
push up and toward oven center to look.
i
NOTE: Do not operate the hood without the filters in
ptace_
CHARCOAL F_LTER REPLACEMENT
If your oven is vented inside, the charcoal filter (part
#507269) should be replaced every 6 to I2 months,
and more often if necessary. The charcoal filter cannot
be c_eaned. To order a new charcoal finer, contact the
Parts Department at your nearest Sears Store or
Service Center,
t. Remove the two vent griLtemount{rig sctews
(2 middle screws)
2. Tip the gril}e forward then iift it out
3. Remove old filter.
7
2 Se_k grease filters in,hot water and a miid
detergent. Rinse wen and shake to dry. Do not use
ammonia or place in a dishwasher. The
afuminum will darken,
4. Slide a new charcoai filter intoplace. The filter
should rest at the angle shown.
5. Slide the top of the vent cover into place. Push the
bottom until it snaps into place, Replace the
mounting screws. Turn the power back on at the
main power suppty.
- 27