Filter
Top Products
Rev 0.0 21
USER INSTRUCTIONS
EN
5 TROUBLESHOOTING
The dishwasher is fi tted with a diagnostics system which detects and signals
certain types of malfunctions.
5.1 Table of faults reported by the diagnostics
system (see tab. 5-01a, 5-01b)
FAULT DESCRIPTION
E1
Acquastop failure
The anti-fl ooding system has tripped (only for models fi tted with this feature).
Activates in case of water leaks. Contact the technical assistance service.
E2
Safety level
The system limiting the water level in the dishwasher has tripped. Interrupt the
current program. Switch off the dishwasher, switch it back on again, program
a new cycle and press start. If the problem persists, contact the technical
assistance service.
E3
Water heating malfunction
The water is not heated or is incorrectly heated. Repeat the washing program. If
the problem persists, contact the technical assistance service.
E4
Water temperature monitoring malfunction
Interrupt the program and switch off the dishwasher. Switch it back on again,
program a new cycle and press start. If the problem persists, contact the
technical assistance service.
E5
Water intake malfunction
The appliance does not take in water or does so incorrectly. Make sure the water
connections are correct, that the water supply tap is open and that the fi lter is
not clogged. If the problem persists, contact the technical assistance service.
E6
Water pump-out malfunction
The appliance does not pump out the water or does so incorrectly. Make sure
the drain hose is not kinked or crushed and that the siphon and fi lters are not
clogged. If the problem persists, contact the technical assistance service.
Tab. 5-01a