Filter
Top Products
Rev 0.0 25
INSTALLATION INSTRUCTIONS EN
PLUG IS NOT SUITABLE FOR THE SOCKET, CALL IN A QUALIFIED
ELECTRICIAN TO FIT A SUITABLE PLUG.
The plug at the end of the power cord and the corresponding socket must be
of the same type and must conform to current regulations governing electrical
appliances. The plug must be accessible after installation. Never remove the
plug by pulling on the wire. If the power cord is damaged, have it replaced
by the manufacturer or an authorized service centre.
DO NOT USE EXTENSION CORDS, ADAPTORS OR SHUNT CON-
NECTIONS IN ORDER TO AVOID THE POSSIBILITY OF OVERHEAT-
ING OR BURNING, WITH CONSEQUENT FIRE HAZARD.
IN THE EVENT OF DAMAGE TO THE SUPPLY CORD, HAVE IT RE-
PLACED BY THE MANUFACTURER OR AN AUTHORIZED TECHNI-
CAL SERVICE CENTRE IN ORDER TO AVOID ANY RISK.
5.3 Commissioning
5.3.1 Installation procedure (all models)
Clean the underneath of the worktop lying over the dishwasher door (see fi g.
5-15) and apply the steam guar
d, as shown in fi g. 5-16 (see fi g. 5-16 if the
adhesive guard is applied; see fi g. 5-17 if the steel guard is applied). This guard
protects the worktop from steam and condensation when the door of the dish-
washer is opened at the end of the washing cycle.
Fig. 5-15