Filter
Top Products
CLEANING MODEL EZ-3 & EZ-5 COUNTERTOP STEAMERS
particles left on the surface will rust and further spoil the appearance of the finish. NEVER USE A WIRE
BRUSH, STEEL SCOURING PAD, SCRAPER, FILE OR OTHER STEEL TOOLS. Surfaces which are
marred collect dirt more rapidly and become more difficult to clean. Marring also increases the possibility
of corrosive attack. Refinishing may then be required.
SEMIANNUAL CLEANING
At least twice a year, have your Southbend Authorized Service Agency or another qualified service
technician clean and adjust the unit for maximum performance. Semiannual cleaning should include the
following:
1. Remove rear cover.
2. Place a (1) gallon container under the water seal box drain valve (see Figure 18 on page 29).
3. Open drain valve, and close valve when box is finished draining.
4. Add one gallon of deliming solution to the trough above the door.
5. Add two gallons of deliming solution through the door into the cavity
6. Turn unit on, let run for 30 minutes.
7. Turn unit off and drain all solution from the cavity.
8. Drain solution from water seal box as in steps 2 and 3.
9. Fill unit with clean water THROUGH THE TROUGH and drain. Repeat 2 times.
Consult the Southbend Authorized Parts/Service Distributor list for the Authorized Service Representative in
your area or contact Southbend at 1-800-348-2558 for this information.
CLEANING
PAGE 14 OPERATOR’S MANUAL 1178387 REV 5