Filter
Top Products
TROUBLESHOOTING SEZ SERIES COUNTERTOP STEAMERS
PAGE 24 OPERATOR’S MANUAL 1183437
TROUBLESHOOTING
Figure 7
Voltage Check at Control Panel Fuse Block
Door Switch
Control Panel
Fuse Block
Power Switch
Terminal
Block
“SERVICE REQUEST”
Light
“ON” Light
1. DISCONNECT POWER AT CIRCUIT BREAKER.
2. Remove control panel without disconnecting plug.
3. Turn lever to “ON” position.
4. Reconnect power.
5. Place leads as shown for test being performed.
6. Check that the voltage is in the range 200 to 240 volts.