Sub-Zero Freezer Freezer User Manual


 
3
Dimensions in parentheses are in
millimeters unless otherwise specified.
TOOLS AND MATERIALS REQUIRED
T
he following is a list of tools and materials
that should be available for proper installation.
Phillips screwdriver set
S
lotted screwdriver set
Torx drive screwdriver set
4' (1.2 m) of
1
/4" copper tubing and saddle
valve for the water line—part #4200880
(do not use self-piercing valves)
Copper tubing cutter
Level—2' (.6 m) and 4' (1.2 m) recom-
mended
Appliance Dolly able to support 700 lbs
(317 kg) and adequate manpower to
handle the weight of the unit
Various sized pliers
Wrench set
Allen wrench set
5
/16" hex bolt nut driver
Crescent wrenches
Cordless drill and assorted drill bits
Masonite, plywood,
1
/8" pressed fiberboard,
cardboard or other suitable material to
pr
otect finished flooring
Appropriate materials to cover and protect
the home and its furnishings during instal-
lation
INSTALLATION
RECOMMENDATIONS
The importance of the installation of the
Sub-Zero Built-In unit cannot be overempha-
s
ized. Installation should be done by a
qualified installer.
Before you begin the installation process, it
is recommended that you read this entire
I
nstallation Instructions book. There are key
details that you should take special care to
observe during the installation. By reading
these instructions carefully, you will make the
installation process easier, problem-free and,
most importantly, safe.
Any questions or problems about the
installation should be directed to your
Sub-Zero dealer or the Sub-Zero Customer
Service Department at 800-222-7820 or e-mail
customerservice@subzero.com. You can also
visit our website at subzero.com.
BUILT-IN INSTALLATION RECOMMENDATIONS