Sunbeam EM8800 Espresso Maker User Manual


 
The cleaning programme allows complete
removal of coffee oils even in areas which are
not normally accessible. Start the cleaning
programme at the latest when the ‘CLEAN’
indicator begins to flash.
The cleaning process takes about 8 minutes
and should not be interrupted. If it is
interrupted the cleaning process has to be
started again.
Important: Prior to starting the cleaning
programme, clean the coffee brewing unit
and empty the coffee waste container. Refill
the water reservoir with approximately 1 litre
of fresh water.
Important: Use the Sunbeam ‘Cleaning’
tablets only. If using other cleaning agents,
Sunbeam will not be liable for any damage.
Sunbeam cleaning tablets are available from
selected appliance retailers or from Sunbeam
on 1800 025 059.
Turn the coffee bean hopper to the
pre-ground coffee position. Wait until the
mechanism has adjusted itself and all the
indicators of the coffee strength settings
are illuminated. See figure 56.
Pull the empty coffee waste container out
and position below the coffee pour spout.
It will serve as a collecting container for
the cleaning water. The coffee waste
container indicator will illuminate as long as
the container is pulled out. See figure 57.
Drop a cleaning tablet into the pre-ground
coffee receptacle, press and hold for 3
seconds the ‘CLEAN’ button, the ‘CLEAN’
indicator changes from a flashing light to
a constant light. The cleaning programme
will commence, the process should not be
interrupted. See figure 58.
32
Starting the cleaning programme
Figure 56
Figure 57
Figure 58