Filter
Top Products
14
Model BC12Operating Procedures
Step 6
Release the switch to s top the agit ator.
Figure 21
Daily Cleanin g
Taylor recommends daily cleaning and
sanitizing.
ALWAYS FOLLOW LOCAL HEALTH CODES
Step 1
Prepare a sink with an approved cleaning solution
(examples: Kay-5r or Stera-Sheenr). USE HOT
WATER (110_F/43_C) AND FOLLOW THE
MANUFACTURER'S SPECIFI CATIONS. Do not
use a solution that contains ammonia and avoid
placing components in a dishwasher.
Step 2
Disconnect power from the wall
receptacle before performing the following
steps. Failure to comply may result in electrical
shock.
Step 3
Remove the splash guard by squeezing the sides
until it is c lear of the top pivot pins and then pulling it
out. Take it to t he sink for cleaning and sanitizing.
Figure 22
Step 4
Wash the splash guard in the appr oved c leaning
solution.
Step 5
Wipe clean all stainless steel surfaces with an
approved, non-abrasive commercial cleaner. This
includes the mixer, dispenser, and organizer
surfaces.
Step 6
Clean sticky switches with a clean cloth, dampened
with cleaning solution. Clean ar ound the edges of
the switch paddles until they function freely. Work
the switches back and forth a f ew t imes to loosen
any dried r esidue under the switch. Dry the switches
withasoftcottoncloth.
Note: Leaving the switches sticky will damage or
burn them out.
WARNING: Do not spray water or other
liquid around the motor chamber. Do not use
excess liquid around the switches, motor protector,
power cords, or cord entry hole. M ake c ertain all
areas in and around the motor are dry before
connecting power t o t he wall receptacle. Failure to
comply may cause equipment damage or
personal injury due to electric shock.