Filter
Top Products
13
Model 104 Operating Procedures
Step 3
Place the plastic scraper blades on the beater, m aking
sure one end of the blade is up against the notch at the
front of the beater.
Figure 8
Holding the beater and blades securely, slide the
beater into the freezing cylinder about one--third of the
way in. Looking into the freezing cylinder , align the hole
at the rear of the beater with the flats on the end of the
drive shaft.
Figure 9
Slide the beater the remainder of the way into the
freezing cylinder and over the drive shaft. The beater
should fit snugly but not s o tight that the beater cannot
be turned to engage the drive shaft. When in position,
the beater will not protrude beyond the front of the
freezing cylinder.
Step 4
Assemble the freezer door. Place the large freezer
door o--ring in the groove on the back of the freezer
door.
Figure 10
Step 5
Press the o--ring into the groove on the back of the
draw plate and lubricate lightly.
Figure 11
Lay the draw plate, o--ring face down, over the ejection
port.
Figure 12