Filter
Top Products
22
Model C722Important: To the Operator
Enable the AUTO START TIME by selecting the UP
arrow symbol to move the arrow to “Enable.” Touch
the SEL symbol to advance to the next screen.
(See Figure 27.)
AUTO START TIME
00:00
Change
>Exit
Figure 27
Program the AUTO START TIME by selecting the
UP arrow symbol to move the arrow to “Change.”
Touch the SEL symbol to advance to the next
screen. (See Figure 28.)
AUTO START TIME
00
:00
Figure 28
Use the arrow symbols to program the AUTO
START TIME by increasing or decreasing the hour
setting above the cursor. Touch the SEL symbol to
advance the cursor and program the minutes
setting. Select the SEL symbol to return to the
previous screen with the new time setting displayed.
Select the SEL symbol to exit the screen and return
to the Manager's Menu.
The STANDBY option is used to manually place
either side of the machine in the Standby mode
during long, no draw periods. Select the STANDBY
screen from the Menu. Touch the SEL symbol to
activate Standby.
Discontinue Standby operation by exiting the
Manager's Menu and selecting the AUTO mode.
(See Figure 29.)
STANDBY MODE
LEFT
RIGHT
>Exit
Figure 29
The MIX LEVEL AUDIBLE option, when enabled,
will alert the operator with an audible tone when
there is a mix low or mix out condition. The following
screen is displayed upon selecting this option.
(See Figure 30.)
MIX LEVEL AUDIBLE
ENABLED
> Enable
Disable
Figure 30
Disable the audible tone feature by selecting the
DOWN arrow symbol to move the arrow to
“Disable.” Select the SEL symbol to save the new
setting and return to the Manager's Menu. The
control panel icons for Mix Low and Mix Out will light
as the mix level drops in the hopper but the audible
tone will be disabled.
The FAULT DESCRIPTION screen lists any faults
detected by the control and allows the Manager to
clear them from the syst em. Faults are displayed on
the second and/or third line. (See Figure 31.)
FAULT DESCRIPTION
L: Beater Overload
R: Beater Overload
Figure 31
Pressing the SEL symbol displays the next fault or
returns to the Manager's Menu if no other faults
exist. Pressing the SEL symbol any time faults are
displayed will clear corrected faults upon returning to
the Manager's Menu. Press the Menu symbol to
return to the Manager's Menu.