Filter
Top Products
12
Model 161Important: To the Operator
If the beater motor is turning properly, press the WASH
key to cancel the cycle. Press the AUTO key on both
sides of the unit to resume normal operation. If the
freezer shuts down again, contact a service
technician.
Feed Tube
The feed tube serves two purposes. One end of the
tube has an orifice (hole) and the other end does not.
Figure 5
1. After priming the machine, place the orifice end
of the feed tube into the mix inlet hole. Every
time the draw handle is raised, new mix and air
from the hopper will flow down into the freezing
cylinder. This will keep the freezing cylinder
properly loaded and will maintain overrun.
2. During long “No Sale” periods, remove the feed
tube. Place the end of the feed tube without the
orifice into the mix inlet hole. This will prevent
any mix from entering the freezing cylinder .
The feed tube maintains overrun and allows
enough mix to enter the freezing cylinder after a
draw.