Filter
Top Products
23
Model 161 Troubleshooting Guide
Section 8 Troubleshooting Guide
PROBLEM PROBABL E CAUSE REMEDY PAGE
REF.
1. No product being
dispensed.
a. The power switch is in the
OFF position.
a. Place the power switch in
the AUTO position.
17
b. The mix level is
inadequate in the mix
hopper.
b. Fill the mix hopper with
mix.
18
c. The beater motor
overloaded.
c. Reset the freezer .
11
d. The unit is unplugged at
the wall receptacle.
d. Plug in the power cord.
3
e. The circuit breaker is
tripped or the fuse is
blown.
e. Place the circuit breaker in
the “ON” position or
replace the fuse.
-- -- --
f. The freezer door is
incorrectly assembled.
f. See “Operating
Procedures” for proper
installation.
14
g. Product is being drawn off
in excess of the freezer’s
capacity.
g. Stop drawing product and
allow the unit to recover .
-- -- --
2. The machine will not
operate in the AUTO
mode.
a. The unit is unplugged. a. Plug in the power cord.
3
b. The refrigeration system is
not activated.
b. Momentarily raise the
draw switch to activate the
refrigeration system.
-- -- --
c. The circuit breaker is
tripped, or the fuse is
blown.
c. Place the circuit breaker in
the ON position or replace
the fuse.
-- -- --
d. The beater motor
overloaded, causing a loss
of power to the power
switch.
d. Reset the freezer.
11
3. The product is too stiff. a. The control is set too cold. a. Contact service
technician.
-- -- --