Filter
Top Products
11
Model 430 Torque Operating Procedures
Section 6 Operating Procedures
The Model 430 freezer is designed to produce shake
or slush product at the desired thickness. This unit has
a 4 quart freezing cylinder.
We begin our instructions at the point where we enter
the store in the morning and find the parts
disassembled and laid out to air dry from the previous
night’s brush cleaning.
These opening procedures will show you how to
assemble these parts into the freezer, sanitize them,
and prime the freezer with fresh mix in preparation to
serve your first portion.
If you are disassembling the machine for the first time
or need information to get to this point in our
instructions, turn to page 17, “Disassembly”, and start
there.
Assembly
Note: When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube).
Step 1
Lubricate both grooves on the drive shaft and slide the
o- ring in place. Lubricate the o- ring and shaft portion
that comes in contact with the bearing. DO NOT
lubricate the square end of the drive shaft. Lubricate
the boot seal groove and slide the boot seal over the
shaft and groove until it snaps into place. Fill the inside
portion of the seal with 1/4” more lubricant and evenly
lubricate the end of the seal that fits onto the rear shell
bearing. Install the drive shaft.
Figure 4
Note: Do not install the boot seal inside out.
Insert the beater drive shaft into the rear shell bearing
and engage the square end firmly into the female
socket of the drive unit. Be certain that the drive shaft
fits into the drive coupling without binding.
Figure 5
Step 2
Install the beater assembly. First check the scraper
blade for any nicks or signs of wear . If any nicks are
present, replace the blade. If the blade is in good
condition, place the clip over the blade and install the
blade and clip on the beater assembly. Be sure the
holes in the blade and the clip are securely positioned
over the beater pin.
Figure 6