Filter
Top Products
21
Model 430 Torque Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
5. Product too thin. a. Missing, incorrectly installed,
or bad scraper blade.
a. Install or replace scraper
blade.
11
b. Improper mixing of product. b. Carefully follow directions
for mixing product.
---
c. The viscosity adjustment is
set incorrectly.
c. Adjust accordingly. 10
d. Incorrect beater rotation. d. Contact service technician. ---
e. Dirty condensers. e. Clean regularly. 18
6. Scored walls of freezing
cylinder.
a. Broken pin on beater
assembly.
a. Repair or replace beater
assembly.
---
b. Front bearing worn or
missing.
b. Replace or install front
bearing.
12
7. Excessive leakage into
rear drip pan.
a. Improper or inadequate
lubrication of drive shaft
seal.
a. Use correct lubricant
(Taylor Lube) and follow
lubrication procedures.
11
b. Bad or missing seal on drive
shaft.
b. Replace seal every 3
months.
22
c. Worn rear shell bearing. c. Contact service technician
for replacement.
---
8. Excessive leakage from
door spout.
a. Improper or inadequate
lubrication of draw valve
o- rings.
a. Use correct lubricant
(Taylor Lube) and follow
lubrication procedures.
11
b. Bad or missing o- rings on
draw valve.
b. Replace o- rings every 3
months.
22
9. Unable to remove drive
shaft.
a. Lubrication on square end of
drive shaft.
a. Do not lubricate square
end. Contact service
technician for replacement.
11
b. Rounded corners of drive
shaft, drive coupling, or both.
b. Contact service technician
to replace drive shaft, drive
coupling, or both.
---