Filter
Top Products
3.0 SETUP MODE
This section describes the setup variables which are used to configure the Monitor. All
the setup variables are stored in the Monitor's EEPROM and are retained during power
off and even when new software revisions are installed.
NOTE
If a variable is modified, but ENTR is not pressed, the variable will
not be changed and the monitor will beep when exit is pressed.
The setup menus are accessed by pressing the SETUP button from the instrument’s main
menu. The top level setup menu is shown in Figure 3.1 below.
ALRM
UNIT COMMCLK VARS DIAG EXIT
SETUP A.8
FIGURE 3.1 - SETUP MENU
P/N 02826B1 Teledyne API Model 450H O
3
Monitor Instruction Manual - Page 33