Toastmaster XO-1N Convection Oven User Manual


 
CLEANING:
Your XO–1N should be cleaned daily and as soon as possible after a spill has occurred. It is essential to maintain a
clean unit, especially if the public views the unit in your place of business. The following should be used for cleaning:
A. The stainless steel exterior may be cleaned with any good stainless steel cleaner or polish, or with hot soapy water
followed by a clear rinse if it is very soiled.
B. The Door can be removed for ease of cleaning by opening the Door slightly and using a ½” wrench or socket,
remove the top hinge bolt and tilt Door until it is clear of the top hinge and then lifting the Door straight up. Do not
loose the bronze bushings from the top or bottom hinges, the door will not operate properly without them. All glass
should be cleaned with a glass-cleaning formula. Baked-on or excessive soiling can be removed with soap and
hot water followed by a thorough rinse with fresh clean water. Severe deposits may be loosened and removed by
soaking in a stronger soap and water solution.
C. The Oven interior should be cleaned on a regular basis with mild soap and hot water followed by a thorough rinse
with clean fresh water. Wipe all items dry to prevent water spotting.
* * * CAUTION * * *
TOASTMASTER
®
DOES NOT RECOMMEND the use of any strong commercial or caustic product on this equipment.
DO NOT allow any type of caustic cleaner to come into contact with any aluminum parts (such as Door frames), the
silicon rubber Door Gaskets, or any of the sealing compound in the Oven seams and joints. These compounds may
cause discoloration and degradation of these parts resulting in permanent damage. DO NOT use bleach or bleach
compounds on any chromed parts; bleach may damage chrome plating.
NOTE:
TOASTMASTER
®
has had very good results with a product called JIFFY CLEANER. For standard cleaning simply
spray JIFFY on and wipe off. Heavily soiled areas may require a short period of soaking. This cleaner is available
through TOASTMASTER
®
(Part #51–0002) or through your local Rochester/Midland distributor or representative.
* * * NOTICE * * *
NATIONAL SANITATION FOUNDATION GUIDELINES REQUIRE THAT ALL INTERIOR PARTS
BE REMOVABLE WITHOUT THE USE OF TOOLS. THIS EQUIPMENT HAS BEEN FACTORY
ASSEMBLED TO SAFELY ACCOMMODATE ROUGH HANDLING THROUGH SHIPMENT AND
ORIGINAL INSTALLATION. AFTER ANY MAINTENANCE, CLEANING OR REQUIRED SERVICE
WORK THE INTERIOR SHEET–METAL PARTS SHOULD BE RE–ASSEMBLED AND FASTENED
HAND–TIGHT ONLY, BUT STILL REMAIN TIGHT ENOUGH TO PREVENT ANY RATTLE OR
MOVEMENT OF PARTS.