Filter
Top Products
INSTALLATION AND INITIAL START–UP:
A. Check to determine that the power source is the same voltage and phase as that indicated on the label on the side
of the unit.
B. Attach the included Appliance Legs to the bottom of the unit. Each Leg stud screws into a threaded hole in each
corner of the base.
C. Position the unit where it is to be operated and adjust the Appliance Legs so the unit stands level and solid.
TOASTMASTER
®
recommends a minimum 1” spacing all around the sides and back of the unit when installed.
D. Carefully set all Controls and Switches to the OFF position.
E. Connect your unit with the attached 120 volt/20 amp Power Cord to a 120 volt/20 amp receptacle (NEMA 5–20R or
the equivalent). Allow enough slack in the Power Cord to allow for equipment to be moved about during installation
and any future servicing.
F. Open the Oven Door. The Blower Wheel should slow to a complete stop.
IMPORTANT NOTICE: ALLOW THE BLOWER WHEEL TO COME TO A COMPLETE STOP
BEFORE REVERSING THE OVEN MOTOR. FAILURE TO DO SO MAY RESULT IN DAMAGE TO
THE MOTOR OR SWITCH!
G. Set the Temperature Control to 300°. The Temperature Control Indicator Light will illuminate and the Oven will
begin to heat up.
H. Set the Timer to 5 minutes and allow it to count down to 0. The Buzzer should sound at the end of the timed cycle.
If the Buzzer and/or Timer does not work please refer to the TROUBLE–SHOOTING GUIDE.
I. Remove the Rear Access Panel to expose the Power Cord connections. Use a multi-meter to measure the amperage
on the power supply lines. Compare these readings to the label on the side of your unit. If the readings and label
differ by any great amount turn the unit OFF and call the TOASTMASTER
®
Service Department immediately at (906)
863-4401. Carefully replace the Rear Access Panel if the amp readings and label coincide.
J. Place an accurate and reliable oven thermometer in the center of the Oven and allow the Oven to heat to 300°.
Compare the thermometer reading and the Temperature Control setting when the Temperature Control Indicator
Light goes out. If they differ by less than 10° the Oven is ready for use. If there is a difference of 10° or more you may
wish to adjust the Temperature Control calibration. Please call the TOASTMASTER
®
Service Department at (906)
863-4401 before attempting to recalibrate the Temperature Control!!!
IMPORTANT: FAULTY INSTALLATION, IMPROPER USE OR ANY OTHER FAILURE TO
FOLLOW THESE INSTRUCTIONS MAY CAUSE EQUIPMENT DAMAGE OR SEVERE
PERSONAL INJURY, AND MAY ALSO VOID ALL OR PART OF YOUR TOASTMASTER
®
EQUIPMENT WARRANTY!!!
IMPORTANT: THIS UNIT NEEDS TO BE INSTALLED WITH ADEQUATE BACKFLOW
PROTECTION TO COMPLY WITH APPLICABLE FEDERAL, STATE AND LOCAL CODES.