Unified Brands HY-6G(CE) Electric Steamer User Manual


 
4 OM/SM-HY-6G(CE)
OM/SM-HY-6G(CE)
4
The HY-6G (CE) has two independent
cavities, each with its own base-mounted
steam generator.
The unit will be delivered in a heavy carton,
strapped to a wooden skid.
1.0 - Equipment Description
Your Groen HY-6G (CE) HyPerSteam Convection
Steamer is designed to give years of service. It has
two stainless steel cavities (cooking chambers) which
are served by twin, independent atmospheric steam
generators which are gas-heated. A powerful blower
circulates the steam in each cavity to increase heating
efficiency.
Each cavity holds up to three steam table pans (305 x
508 x 64 mm). A 1.5 mm stainless steel case
encloses the cavities, the steam generators and the
control compartment that houses electrical
components. Door hinges are reversible (the doors
may be set to open from the left or right). Operating
Controls are on the front panel.
HY-6G (CE) steamers are equipped with fully
electronic controls and a button-activated,
preprogrammed CLEAN cycle.
The drain system includes a spray condenser, which
helps keep steam from escaping down the
condensate drain.
2.0 - Inspection and Unpacking
Your HY-6G HyPerSteam will be delivered completely
assembled in a heavy shipping carton and attached to
a skid. On receipt, inspect the carton carefully for
exterior damage.
CAUTION
SHIPPING STRAPS ARE UNDER TENSION AND
CAN SNAP BACK WHEN CUT.
Carefully cut the straps around the carton and detach
the sides of the carton from the skid. Be careful to
avoid personal injury. Strap edges may be very
sharp, particularly where cut. Write down the model
number, serial number and installation date. Space
for these entries is provided in the Service Log at the
back of this manual. Keep the manual near the
equipment for reference and update as needed.
CAUTION
THIS UNIT WEIGHS 550 LBS. (250 KG). GET
HELP AS NEEDED AND USE MATERIAL
HANDLING EQUIPMENT TO MOVE IT.
When installing, use material handling equipment to
lift the unit straight up from the skid. Check packing
materials for any loose parts.